4. Electronics

Tools for this section

• 2 mm Hex Screwdriver

• Soldering Iron

• Wire Snips

Parts for this section

• 15 AWG Silicone Wire

• (12x) Bullet Connector (female)

• (12x) Heat Shrink Tubing

• (4x) M3x16mm Button Head Screws

• (1x) ARK FPV Flight Controller (Not Included)

• (1x) ARK 4 in 1 ESC (Not Included)

• (1x) FPV VTX (Not Included)

• (1x) RC Receiver (Not Included

Step 1: Soldering ESC Wires and Mounting Electronics

Step 2: Proceed with wiring relevant electronics

Examples of RC Receiver Antenna Mounting

Examples of Analog VTX Mounting

ARK FPV Docs

ARK FPV | ARK Documentation

ARK 4 in 1 ESC Docs

ARK 4IN1 ESC | ARK Documentation

Double-check all your electronics wiring before proceeding to the next step.

Check:

• The motor direction is correct.

• Battery lead polarity to ESC is correct.

• All signal wires are correct.

• USB-C extension is plugged into the flight controller.

You are ready to move on to Section 5.